I'm building a mini bike from scratch plus Azusa frameless 8" kit and Predator 212 engine. I've tried to read as much as I could before and during the build. Why is it so difficult to find some basic dimensions like wheel spacing, inside frame minimums, etc.? So far I've been working on it for about a week. I go to my shop at 4:00 am for a couple of hours before going to work.
The frame is 1" square tube, which is not typical I know, but that is what I had. The only steel I've bought is a stick of 7/8" tube for the handle bars/forks and a stick of 3/16" x 1.5" cold roll for the front axle tabs. I will finish the forks in another day or 2 and then finish fabricating the motor mount/floor board.
I have cut the forks to length since this picture was taken.
Let me know your thoughts, suggestions, recommendations, or especially any CAUTIONS that I should know.
:grind::hammer:
The frame is 1" square tube, which is not typical I know, but that is what I had. The only steel I've bought is a stick of 7/8" tube for the handle bars/forks and a stick of 3/16" x 1.5" cold roll for the front axle tabs. I will finish the forks in another day or 2 and then finish fabricating the motor mount/floor board.
I have cut the forks to length since this picture was taken.
Let me know your thoughts, suggestions, recommendations, or especially any CAUTIONS that I should know.
:grind::hammer: