This coupon came out of our local paper in Eugene, Oregon. These coupons have been posted before and simply printed and used. In regards to mounting bolts, mine did not come with them.
Hi,
I just got this engine.I also got a comet 12 tooth clutch.My question is,what do I need specifically for parts to go with the clutch.You know,to keep it from sliding/moving on the shaft?
You should have a slotted shaft. Put your shaft key in the slot. Then line up the slot on the clutch and gently slide or tap it on. Tighten down the set screw on the clutch. Your in business!
if there's a threaded hole in the end of the shaft, get a bolt and washer to help hold it on. you need a washer that's a bit bigger than the diameter of the clutch.
You should have a slotted shaft. Put your shaft key in the slot. Then line up the slot on the clutch and gently slide or tap it on. Tighten down the set screw on the clutch. Your in business!
Ok great,Thanks Neil&DJ.Yea my clutch slides right on the shaft.I just couldn't figure out what kept it in place.After reading your post,then re-looking at my clutch,I now see a little hole at the back of the clutch.This must be the set screw,your talking of.It sure looks awful small though.
if there's a threaded hole in the end of the shaft, get a bolt and washer to help hold it on. you need a washer that's a bit bigger than the diameter of the clutch.
i had my clutch almost slide off a few times because the set screw wouldn't get tight enough without stripping it. now with the bolt i'd never had a problem.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.