Motovox MBX10 Top speed

[Aldovino]

I unscrewed the governor half way last night and I was flying down the road; it felt like I was going 35+ I was wondering if this is bad for the engine to overide the governor like that... I have a lot more engine to go, it can be unscrewed a lot more, and I was just wondering the top speeds recorded on these with the governor bypassed and if it is terrible for the engine? Thanks! I am also working on putting an exhaust for a more quiet noise plus adding a little more power, any recomendations? :laugh:

 

[Norcalputput]

Fly wheel and connecting rod are very important to preserving your engine, groin, and smile
Following instructions to install them is just as important
You have pulled the pin on the gernade now wait and see



Sent from my iPhone using Mores code

 

[Jaymo]

Fly wheel and connecting rod are very important to preserving your engine, groin, and smile
Following instructions to install them is just as important
You have pulled the pin on the gernade now wait and see



Sent from my iPhone using Mores code

Preserving my groin is very important in order to protect my smile.

 

[cheezy1]

Here is an interesting read for you. This may answer your question.
http://www.oldminibikes.com/forum/h...governor-engine-OldMiniBikes-please-read.html

 

[dakota]

I don't think you will hurt that little motor by screwing the Gov screw out a little. `everybody does it. just don't go any further.