This is my rear set up,I have been trying to get the sprocket on center to allow the chain to flow smoothly(with no tight then loose spots..It is a drum brake as well..
I have been trying for 4 years to do it w/ no luck!!!!drilling different holes,trying to measure from the axle to the teeth,then drill,but then the holes never come out where u want them??
I was considering on adding a 1 piece sprocket and drum allready set up..that will solve all my headace's...but then I will have to buy new,chain,clutch & the sprocket as the 1 piece set up is only in #35 chain,now it is #41..Has anyone else had this happen and how to correct?
OH, I do have a nice spring loaded rollerskate wheel set up off the engine to pick up the slack on the chain,but I would rather get it set up to complete a revolution smoother..
thanx
I have been trying for 4 years to do it w/ no luck!!!!drilling different holes,trying to measure from the axle to the teeth,then drill,but then the holes never come out where u want them??
I was considering on adding a 1 piece sprocket and drum allready set up..that will solve all my headace's...but then I will have to buy new,chain,clutch & the sprocket as the 1 piece set up is only in #35 chain,now it is #41..Has anyone else had this happen and how to correct?
OH, I do have a nice spring loaded rollerskate wheel set up off the engine to pick up the slack on the chain,but I would rather get it set up to complete a revolution smoother..
thanx
Last edited: