assembly

I took apart my 70 Roadster to clean everything up. When I cleaned the motor I took off the TC to clean behind it. It was 45 years worth or dirt and oil. Anyway when I put the TC back on I noticed a little slop in the spacer. Bigger than a 1/16" smaller than an 1/8". I pulled it apart looked at...

I know its a long shot But I would like to find a assembly guide for a heathkit boonie bike Pm if you have one to sell..

I have been assembling a Bonanza with a Hodaka motor. Does anyone have tips on how to assemble the springs into the spring retainers? Thanks

Caliper, Adjustable 7/8" Lever, Cable and weld on mounting tab....$20. shipped This setup was being used on the sprocket of an Arco and worked well..

Just curious..... Is there a high need for these things?:shrug: If so......I may make a dozen of the linkage kits...

Came off a running tiller , no dents , no rust , $25 plus shipping from 70737 , pay pal is best but I'll take any kind of $$ , thanks

Very nice shape,small tear in the bronco word mounting studs in good shape $95 Bronco throttle assembly with cable $75 Bronco brake lever and cable $40

Im.looking for a og throttle assembly an grip an cable .for a trailhorse bike pm.me or call or text me at 407-860-8314 thanks.

Can anyone lead me to where I can buy the throttle assembly? I got a grey hound (Honda clone) this past summer on a bike. I went to put stuff back together today and realized I was missing the stock throttle assembly. The PO removed it to put on a racing set up. Thank you

I need a Super Bronc vt8 front fork assembly. Forks,shock tubes and springs. I could even use the handlebars too. Thanks for any assistance. Kerry

Can anyone tell me what model number this Comet assembly is? And if any one has a blow-up of it? Please advise I'm wondering if there is a spring and washer in these like the Rupp torque set-ups. And wanting to see if anything could be sticking in that housing.

Hello, I recently picked up a Hilltopper that was disassembled and in boxes. Does anyone have a copy of the assembly manuel. I will pay for the copies and shipping. I would also buy an original manual if someone has an extra to part with. Pm or post here if anyone can please help. Thanks! Eric

As said in the title I also need the front fender and seat. Any advice on where to find a carb kit would also be great. This is the coffin tank model with the Marinelli Thank you!

I have recently purchased a Herter's mini-bike. It was 90% complete, however the motor was missing. The mini-bike itself has all the original chains, sprockets, and belt going to where the motor was supposed to be (I believe it is called a jack shaft?). My intention was to purchase a harbor...

I need a recoil pull starter for my new project; an 8 HP trike from MW. It's a Tecumseh HM80. Needs to be working and ready to go. Thanks! Roadmaster75

I have a mtd front brake assembly. Has everything you need. Asking $30 shipped

I am putting an H35 together after having received it disassembled. Mounting the ignition assembly (which is in one piece) looks straight forward but the plug wire seems to get compressed a good bit as the two bolts holding the assembly are tightened against the block. I see where I think...

For Sale I have a rare Little Petro rear wheel assembly with Sprocket,rear Axle and axle spacers and nut,all original and in good condition,ready to restore. $30.00 plus $20.00 shipping Paypal gift option or local pickup welcome

I know its a long shot but looking for a Retek Cheetah Headlamp Assembly I also have a Retek Cheetah Gas Tank & Handlebars for sale both original

Looking for kidney bean sprocket and brake assembly. Thanks