I’ve been looking all through Craigslist list and Facebook market place for a bit and I can’t find these bars for my bird project. If anyone has these bars please let me know. I’m looking to pay around $50. Only PayPal goods and services. I hope I’m using this section right
I am hunting for a Roper grab bar.
Original would be great, but reproduction would be fine.
You never know till you ask....right.....:shrug:...:laugh:
Please PM me with any information.
Thank You,
Robert
Need a nice cat slingshot sissy bar. Will trade a caliper or a chain guard. Or some other part. I do not want one of Corey's (bikebuddy's) garbage repops.
Thanks
Hello folks,
We are looking to re-power our Whirlwind. In place of the H40 Tecumseh, we are looking at Honda GX160 or Gx200 power plants. The 4 hp Tecumseh would easily pull the front off the ground. We would like to supply the same amount of low end torque to this machine as the old power...
I'm slowly in the process of refurbishing the 2 MB200s that I bought in September. Things have been going fairly well, but I've run into a problem identifying part numbers for the rubber washers that are attached between the handle bar mounting bracket and the triple T. I assume the rubber is...
Any ideas? The ski is thinner and shorter than most I have seen and is apparently for snow or ice. The rope on it is to keep the tip from dipping if you go over a bump or jump according to the paper with it.. Is nos and is close to a Rupp type orange.
The sissy bar is thicker than a bicycle type...
I just picked up a DB30 new style mini bike with the swept back handle bar. I'd really like to bend them up to be more like the old style doodle bug. Can someone tell me if this is possible without destroying them? I read a few threads about this but there was never really a clear answer...
I'm looking for the clamps for the handle bars that fit a Ruttman Spyder or Lil Indian mini bike, does anyone know where I can find a set of the OE style clamps?
I know it's been done a million times, but we put a wheelie bar on a Sears Roper. Maybe we over did it lol. What do you think?
btw, thanks to all of you who subscribed when we put the engine video up, you guys are awesome!
https://youtu.be/njN4hLmdu-Q
well ive been making a little progress on my ruttman , i still need to gather a few parts but step one is completed fresh paint , i used two part epoxy for the primer and utec polyurethane for the top coat , i figured blue would look good on it ....
before
after
in the next few...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.