coil?

So I was about to install the lighting coil I bought off ebay on this H60 I aquired a few weeks ago when I realized the coil and flywheel came off an HM80. I could have sworn I bought one from an H60. In any case are the shafts the same size anyway? Also I've heard the taper can be a little...

So I recently bought a small lot of small engines, and one of them is a Briggs 7 horse. I took the cover off and the coil was just laying there with the wire cut to the points behind the fly wheel. I got on eBay and I found this coil (link will be posted below). The new coil fits on the motor...

is there a high performance coil to work with the predators 212cc motor

I'm calling on the guys who restore briggs motors to give me a hand with this one. Can you clean rust off of a coil? is there a solvent you can use? or will it just wreck it? will evaporust work? :shrug: I'm rebuilding some of my 5hp Briggs motors and the coil are the ones that don't use...

On the left is the little known 5hp GX140 coil. On the right is a GX200 coil. 140 coil looks bigger and better. Any opinions?

Ive searched for a replacement coil for my sons H30, and every one I find appear to be just the coil with the spark plug lead. My sons coil seems to be one piece with the metal plate portion and an aluminum part that holds the points. Is the coil seperate from the metal plates and meant to be...

I have a 3hp coil that just dont wanna work. I would like to get them new(hate messin with used crap). If u can please leave a link to ebay or OldMiniBikes that would be great. I need two of them.

My friend and I are building performance 6.5's (fairly mild, 6000 RPM bursts). We do quite a bit of riding at night though, so we'd like to run a headlight. Does anyone make a lightened flywheel with the magnets in it for a charging coil? Has anyone had luck epoxying the magnets to an...

Im assuming the magnet next to the flywheel is the coil, just never really thought about it...Am I right in assuming this? Also, what is the spacing between the magnet and flywheel. I just kind of judged it by sight, but have a feeler gauge now, and can place it within spec if someone was so...

Anyone know where I might be able to find a genuine Honda coil for around $20? Ive seen em for somehitng like 50, but Im not able to pay that much for it. lol. Yes, clone coils are like $15-20, but if I can get a Honda coild that would be loads better... :shrug: Thanks, Beal.

found another thread sorry

i have a five horse briggs and a 12hp the 12hp has a lighting coil, and i was wondering if it would mork on my 5hp

hey i need a coil for a briggs 5hp flathead, its a fun power. made in 1997 i think. the cheaper the better. thanks.

I want a good H50-H70 engine for my trailmate with a lighting coil. I've been seeing that they re getting harder to find and all those other guys with the Rupps and what not want them big time. Like Paying out the A$$ for them. I'm a cheap sunuva so if there a way to put the lighting coil...

so last week i was riding my moni bike around its a 6.5 clone with a few mods i have a race today with it no i have no spark i pulled to plug out held it on the motor pulled a few times no spark the motor ran great last week now this do these coils just dump out laike that or could it be...