6.5 horsepower block with - these modifications done by an official small engines experiment
"Killer engine built by 125CCRAZY"308 cam
new honda flat top piston
file fit rings
arc flywheel
8mm plug wire
champion rockers
chr push rods
raceseng guide plate
new intake
26mm mikuni
28.5mm int 25mm...
10" spoke front rim with drum brake complete $40. Just joined today as I'm looking for some parts and have some to sell I'm new here but been selling on eBay for 15 years 100% positive feedback
looking to buy an El Tigre (bird industries) seat, and a tecumseh 3.5hp slanted intake manifold and a rupp scrambler front "racing" plate. thanks and let me know, Lyle
Building what I think is an MTS-50, it has 22-11-8 knobbys on the rear, my question is what works best on the front? a turf tire or a matching knobby only smaller? will a knobby on the front be too aggressive or bouncy?
comments and ideas appreciated.
Randi
Hello all,
I'll make this short and sweet. I have a KENDA 4.00 - 8 tire, mounted on a 8 x 3.75 wheel as my rear wheel that I am more than happy with. I was wondering if you guys could give your opinions / suggestions on what would be cool on the front. I'm having a little problem digesting all...
Normally it would be a who cares topic ....
Stock tire size is 5.30x4.50-6
I could not find that size in a similar tread pattern but was able to find a similar tread pattern in a 15x6.00-6.
Its slightly wider and shorter than stock ... I wasnt sure it would fit but got one any way and...
Hello all,
Building my own MB frame and would like some info on the head tube?
Could any one school me on what's all involved?
Basically, what is the anatomy of a basic head tube?
I assume connecting the forks to the main frame with nothing more than a bolt is not a good choice?
Appreciate...
anyone out there have a measurement in between the front forks inside tube to inside tube. my li lindian doesnt have the correct forks on it and mine are 5 inches apart and i trying to stuff a hydrolic disk on my front wheel and i need 6 inches between the tubes. trying to figure out if im going...
I have another Deluxe (shocks on hinged seat mount/sissy bar) that I'll never build. The paint is way gone and the frame has some light pitting but nothing that a sandblaster and finishing wheel would not make nice enough to take primer and paint. The forks are super straight but the bottom of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.