I read some threads on here on how to wire up a killswitch to a predator and I didn't really understand it but I managed to figure it out and couldn't be more happier with the way it turned out and it was extremely easy I mounted the switch to a custom plate I made tell me what u think
This was just too easy to not be worth it. This was just the TC2 kit from gokartusa. We were flying around, climbing hills we couldn't make it up before. Lots of fun for sure.
So I finished by DB30 with 6.5hp power fist motor (honda clone), TAV2, Uni filter, straight pipe, and a jet kit from hot rod mini bikes (whatever one they offer).
So it is all installed and running but after taking it for a rip i came back, took it in the garage and did a 1 minute break stand...
I cleaned the drive put it back together, bought a new belt put everything on and back together. I start it up and nothing. Drive just doesnt seem to be engaging far enough to grab the belt. What do I do? I cleaned it all out everything seems good. are the weights wore out, the springs are...
Before I made my custom header, my engine would always start up first pull with the choke even after removing the governor. But you would still have to give it gas. Now after installing the new header, you have to give it half throttle 5 or + pulls, warm up lap then its able to idle. Is...
New "old style" Doodle with New 6.5 installed
I have a newer (bought new Dec 2010) Old Style Doodle bug with a new harbor freight 6.5 hp and 6.5 engine conversion kit installed.
It has maybe 1hour of total use.
Also Included; original 2.8 with 10 min of run time.
My son laid it...
Hey all;
I Put the TC2 on the mini tote
The TC2 install went smoothe - however now the chain is not lining up - the TC2 torq a verter is further out then wheel sprocked - any ideas before i start trouble shooting this thinG:scooter:
I am just finishing up my son's engine, pretty basic build...
ARC rod and flywheel
honda flat top
stock head milled .060 (ported. ss valves ect)
26lb springs with locks and retainers
308 dyno cam
stock ratio rockers
I just finished putting the valve springs, locks and retainers in...
I had a bad case of insomnia last night, so I took the yellow DirtBug and removed the little 2.8 and installed the HF 6.5 I had new in the box! Now it still has the tank on it cause the seat and everything else is still like new! The tractor type tires leave much to be desired but will do for...
I have had this sprocket for a long time and finally got around to installing it
Install was very easy with the longest part being shortening the chain (needed to take out 7 links and couldn't find my chain breaker so I did it the old school way with a punch)
It just stopped raining out so...
I got in the 3157 style 36-LED bulb today, took a little work to get the socket and bulb into the OEM headlight (creative dremel work to remove the OEM retaining ring and make the opening larger) but it's all together now
Need to get some new rubber washers for the mounts but got it temp...
Got the mikuni carb installed on the super bronc... HOLY CRAP!!! this made a world of difference in performance!!! Now I need to get a billet rod so I can make full use of the carb :thumbsup: So tempting to see what top end is but I havent tried it yet.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.