I was following ctjmini's guide on installing the HF 6.5 clone on my DB. I got to where it told me how to put the clutch on. I took the keyway off and slid the clutch on but the keyway wouldn't go back in when I lined up the notches on the clutch and shaft. Instead of using my head and filing it...
I have just installed a 14cc head from a honda engine. i have a #90 jet and gx140 e-tube. is this an ok set up?? i was told that i need to install the stock e-tube back in the carb since i installed the new head
shoulg I ??
So today i decided to put on the back and front fender of my doodlebug after painting it with some gold stripes! i than decided to film it and put it on youtube, and now am deciding to share it with all you guys!
Please Subscribe to my Youtube channel aswell as rate and comment the video...
Posted this over the weekend but it got lost, and i need help!-
Im putting a TAV on a HF 6.5 and I want to bolt it on horizontally, not on the 2nd set of holes that put it tilted down in back at about 30 degrees, like it is in this picture-
However, putting it horizontally seems...
I think the answer is obvious, but ........... i'm putting a TAV on a HF 6.5 and I want to bolt it on horizontally, not on the 2nd set of holes that put it tilted down in back at about 30 degrees, like it is in this picture-
However, putting it horizontally seems impossible :hammer...
whatsup guys,
so ive got tecumseh HS50-76110A on an old db...and im havin trouble gettin it started...i know the ignition works, the crank shaft turns freely and the piston/vavles function as they should...where i believe the problem lies is in the carb and or governor...the thing is old...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.