shaft?

Found this 6.5hp intek to purchase but has the pressure pump still attached. Anyone know if its more likely to be a straight shaft. Think a couple models were tappered. guy said its a 206cc 121400 ?

Anyone know if this motor will have a tapered shaft? It's on a maxa? generator. I'm thinking about getting it for parts for my HM 80 but would love to just swap it out if it can be done easily. 4kv generator

I am building the jackshaft for my current built. The setup is a live rear Axle (fixed) to a jackshaft to the motor which is joined by a TAV 2 TC. My question is, Do I make the Jackshaft adjustable? The engine plate is going to be slotted so I figure make the jackshaft slotted as well so I...

I received another 3HP Briggs & Stratton ball bearing motor with a threaded 5/8" shaft and was wondering if I should add a keyway on the shaft. I have used clutches on threaded shafts before but I usually just drill where the set screws will be and then tighten it down. I would rather have...

Any idea if this would be a tapered shaft on this or just a standard 3/4" shaft with out tearing the pump off of it? Power Washer

Yellowhand, KKK, any other machinists out there, Is this shaft fixable? I don't think I can use it like it is. The two Keys are worn really bad, and you can see what happened to the shaft. I had the whole bike apart, except for this shaft assembly. I was thinking about just leaving it, but...

all i see is 5/8" in OWB.....i need 1" i.d. x 2" o.d. x 9/16" wide with a retaining clip. ive been looking online for 45 minutes and cant find 1" x 2" bearings without a clip all day. ideas?

i will pay for shipping and time and parts pm me

So if it has shaft listed as "none", what are these types of engines used for? I see that it is threaded into the case, so i'm assuming it's a very small shaft. could one remove a shaft out of an older tired 3.5 and slap it in here? Even though it's a side dump exhaust, it's still...

is it as wide as a honda 5.5 hp or less?

I recently asked around on CraigsList for a tecumseh motor with my fingers very tightly crossed. Today a guy called and said he had a 5HP tec that he would sell for $75 dollars. When I asked him to describe it, here's what he had to say.... The muffler is a pancake style muffler, air filter...

Hey i was wondering if anybody has been successful in shaving down a tapered shaft to and cutting a notch for the clutch key? Sounds doable...

A few thousands is a lot! Is this true? All the shafts measure over 0.625 inches? I don't remember the thread Zipseattle is quoting, but an over sized shaft would be a major bummer for trying to using a popular American made clutch then. My neighbors have the stock motor and are not too handy...