tap

3/4 version. Purchase or rent as I will never use it after this engine.

Hi I was wondering if anyone has one to sell or knows where to buy one. OldMiniBikes warehouse no longer has them and I have a project on hold till I get one. Any help would awesome thanks.

my nephews kids have a doodle bug that killed a 97cc and I want to replace it with a 2hp from an old edger but the crankshaft needs to be drilled and tapped. Being the tightwad that I am is this something I can do myself with a hand drill and Harbor Freight tap and die set? I can't even...

Would this be correct to buy ? 1/2-14 NPT pipe tap

I have a question maybe someone here can answer. The H50 I have has a drilled 1" PTO. I need to tap this for a TC mount-up job. Hole size is unknown but a 5/16 drill will fit with some wobble. I know that a 5/16-24 bolt is common for other shaft diameters but what is workable for the 1"...

Hey yous, what type and size bearings am I ordering for these Roper wheels? And the rear wheel on the right has a spacer that not only goes the length of the inside wheel ,like the front on the left does, but sticks out on both sides. Do I need to keep it like that or can I get new bearings...

I have a great running tec 3.5 hp with at 5/8" crankshaft. I want to tap it to fit a 1/4" bolt to hold on my clutch. I bought a tap and die set from Lowe's. My question is to tap to fit a 1/4" bolt, do I use a 1/4" drill bit followed by a 1/4" tap? I know it sounds so basic, but I only want...

I am looking to get a tap and dye set so I can fix the threads on my crank shaft. They're buggered up on the flywheel bolt threads. What size dye do I need, and can you recommend a good brand? I'm new to the rebuilding engines game but wanted to get some good tools so I could do it and do it...

I bought this fender on Ebay a while back. Surprise, surprise, it's not a 1970 like I was told. I'm pretty sure this is a 1971 and up. The overall chrome looks good, with very light pocking all over. There are a few tiny dents coming from the underside, but they should be easy to tap out. The...

Got this super cool steam punk lookin old tymey oven tank and I want to make it a minibike tank. It's got no hole in the bottom. It looks as though a hose would go on that cap fixture and feed the oven that way. So how much of a pain in the arse is this going to be? My tiny brain is saying I...