Crankshaft tap

[SIMPLEARKANSAN]

Look what came in the mail today. Thanks Sixpac440. I ordered the tap guides from OldMiniBikes that someone else referenced. Sixpac440 sent these items at his cost to make sure I tackle this project correctly. I appreciate all of your help. Once the guides get here I'll document the process. Thanks again for making this such a great site.

 

[SIMPLEARKANSAN]

Got my drill guides from OldMiniBikes. I see one is for 3:4" and one is 5/8" crankshaft. What is the smaller brass cylinder used for?

 

[jretro]

The brass is for use on a 5/8 crank. 1 steel guide is for the tap and the other is for the drill.

 

[SIMPLEARKANSAN]

Jreto not sure of what you mean? Any pics?

 

[johnnyp]

OldMiniBikes sells a drill and tap guide on EBay,



Small Engine Crankshaft Drill & Tap Guides 5/8" & 3/4" Tecumseh Briggs Clutch

I looked and cannot find it. Do you happen to have a link?

 

[sparkwizard]

That comment was made in 2015.

 

[Skipp]

I looked and cannot find it. Do you happen to have a link?

McMaster carr….I made my own….may have a few laying around…