Iron Croos Tote Gote 750 part 2

[Richard Trotter]

Tote Gote 750 project has been on hold, hoping to find better parts. I finally have it to the roller stage. This will be a tribute to the racing Tote gotes used by the 'Timp Trail Riders'.

 

[Stangrcr1]

Can't wait to see you get her done!

 

[fistfullabar]

Nice!! Racer setup extra cool!!:2guns:

 

[Richard Trotter]

Did a mock-up to see how parts will fit, plan for exhaust and front fender mount. This isn't the motor, tank or seat that will be used but they gave me some idea about the fit. Its taken over 2 years to get this far, so I don't expect this to move very fast.

 

[countstevula]

I think it looks great with that motor, tank and seat!

 

[JohnnyTillotson]

That's so cool. I love these Tote Gotes. It is a dream of me to own one someday. I found an old set of bars and forks recently with a fender and it had a mud flap on it. Classy! Well, I THINK they are Tote Gote. Not sure those bars are on anything else... I love just saying it.. TOTE GOTE! Heehee.. Someone just ban me already... Sigh...

 

[rds]

Great job so far, Nice to see you working on the gote again

 

[owend]

Nice to see you back at it again:thumbsup:

 

[Papa Deuce]

Cant wait to see this...I miss my Tote Gote.

 

[TotegoteTrav]

Lookin good Richard!

 

[t555trailblazer]

Nice project! I just recently became a proud owner of a model 750 (purchased from a OldMiniBikes member) . I am in the clean up stage removing dirt, grease and junk to see what I have. I was suprised to see the rear end of the engine mount plate floats on the frame. It looks stock, is that correct?