Predator 212cc Governor Help!!!

[Firebutt]

Hi everyone! I have a Baja Warrior with a Predator 212cc engine. I currently have it all taken apart to repaint, and I decided to remove the governor while I was at it. (And don't worry, I already ordered a new flywheel and rod.) I took apart the engine two days ago, and every since I've been trying to get the governor out! I've probably spent around 3 hours total trying to take the damn thing off, but that little ring clip just won't budge! Does anyone have any tips on how I could make this easier for me? Thanks!

 

[OND]

Yes they are tight little rascals, I just use a flat screwdriver and a hammer ...just distort the crap out of that little clip and trash it all. :laugh:

 

[trinik7597]

really ??? i have never had an issue hit the top one with a hammer and use a hammer and punch on the side ! plug the holes with 1/4 20's done in 15 mins max might as well pull the low oil shut off while you are at it :thumbsup:

 

[chipper]

I used a punch from outside the block and pushed the gear shafts out instantly .

 

[trinik7597]

I used a punch from outside the block and pushed the gear shafts out instantly .

:thumbsup::thumbsup:

 

[OND]

I used a punch from outside the block and pushed the gear shafts out instantly .

Well thats what I do with most of my blocks to, but he asked how to get the clip off . :anon.sml:
:laugh:

 

[trinik7597]

Well thats what I do with most of my blocks to, but he asked how to get the clip off . :anon.sml:
:laugh:

that thing usualy just goes flying when i wack with a hammer :laugh::laugh::thumbsup:

 

[OND]

that thing usualy just goes flying when i wack with a hammer :laugh::laugh::thumbsup:

:thumbsup: :laugh: :laugh: