bonanza

Ive searched and searched and can not figure out how to remove the lower forks from a bonanza. Thanks in advance for any guidance!

I need a set of Cherry grips, my bike has two left sides on it :doah: (7/8 and 1") I might be able to make do with just the throttle side (1 inch) if it's in nice shape Thanks!

Yes, just as fate would have it right when I'm trying to downsize my collection, look at what falls into my lap This will probably never ever happen to me again. Here is the story I received a phone call about three or four months ago from a good friend of mine saying that he knew collector...

project bonanza almost done....im going to go with the original blue and i have the fenders and front nametag ......later post

project bonanza almost done....im going to go with the original blue and i have the fenders and front nametag ......later post

project bonanza almost done....im going to go with the original blue and i have the fenders and front nametag ......later post

Here is a BC1300 I picked up . Had to replace a couple of missing parts . But it's a nice survivor

bonanza mini bike with hodaka motor on craigs list 1 dollar

There is a bonanza bc 1300sh for sale in wichita ks on craigs list,listed under motorcycles by owner

I dont know where I saw it before, on here or just when I was searching google, but I cant find it again. I thought it was either an article or something to that extent not an add but could be wrong. It was a young girl on a scout chopper, in the dirt, almost sliding it or at least dirt...

When I got this, the jackshaft was gone and some doofus had replaced the motor and ran the chain from the motor sprocket back to the rear sprocket. I'm looking at the 5/8" #35 Jackshaft Kit, shown here: https://www.OldMiniBikes.com/jackshaft-kit-for-35-chain.html Anybody here know the OD of...

Hi All, I picked up a minibike recently on C/L, and got looking at it to try and find out what it is and how it should be. Turns out, it's a Bonanza BC1300 mid peg, if I read things right. When I can figure out how, I'll get some photos up. It's a green color with chrome spoke wheels &...

Did any of the older Bonanza have two sets of foot pegs ? A set up on the down tubes and a set midway back. Thanks THANKS

this may have been done before, i don't know. i never liked those 5/16" x 5/8" eyebolts used as chain tensioners. i spun up a couple 1" diameter, 1/2" wide spacers wit h a 5/8" bore. then i took a 1-3/4" fully threaded hex bolt with two nuts and ran them through the tensioner holes. look...

I am looking for 2 sets of really nice fork boots or a set of Strictly hodaka rubber fork boots that someone didn't use. let me know what you have for sale. Thanks

I have five bonanza steel chain guards , copies of course . Made of 18 ga steel sheet and welded together . There are no mounting holes yet , but I can provide engine mounting brackets at an additional cost . Price 75.00 shipped

What was the factory finish on the lower forks on the MX bikes?

Looking for two sets of bonanza foot pegs.

I have decided to part out this MX 1410 roller I picked up a while back. Hadn't had any luck selling it as a roller, for pick up only. So here it goes as a parts bike. Original set of spinner wheels w/sprocket and brake assembly----$150 Replacement set of new tires----$55 Original seat, nice...

Picked this up 2 weeks ago. I recognized the wheels and the frame looked like a scout. cost was very reasonable and it runs. The engine is a hybrid of parts and the brakes do not work well. the tires needed 2 tubes which i did today and i got the brake pads on order from OldMiniBikes. the seat might be...