manifold

my buddy has a HS50 and manifold for a tecumseh 5hp that he doesnt need and i cld get for a good price. Will it bolt up?

Hi all...I am looking for a slant intake manifold for my HS40. Any help would be appreciated. Thanks:thumbsup:

I have a 3 hp Briggs that I want to put a tilly on and need an intake to mount the carb. I don't have the carb yet but am looking at the HL-166C. I have seen this one recommended in the forums.

I need an inexpensive intake but it must be nice so I'll pay accordingly. It must have a pulse hole or trench to run this carb. Pulse fitting as well. :thumbsup:

I need a intake manifold for a mikuni 22mm to a gx200 or clone. If anybody has one that they are not using then I will pick it up from you, before buying one. PM me and we can make a deal.

Looking for a Tillotson to clone manifold. Just wondering if anyone has 1 they dont need before I order one.:shrug: Thanks.

I want to buy a Briggs manifold for a 5hp flat head that fits a hl357 tilly... thanks... if some one just the flanges that would be awesome too... thanks rimfirekyle@hotmail.com

i have a spare 24mm dellorto carb, but i cant seem to find a manifold to put the carb onto a 5hp briggs, i wanted to use it in my rupp hustler, any leads would be great, i would get one made, but i dont have acsess to anything atm, id rather buy one :)

have a 24mm carb stock jetts if like new airfilter has the arc with jet manifold adaptor will fit any honda clone ect asking $35.00 plus shipping or $40 shipped

this is a tecumseh slanted intake manifold pulled from an hs 50 motor that was in running order i changed the motor to a flat plate and dont need this slanted intake so i thought i would see if someone here does i want to get 40.00 plus shipping figure probably 8 to 10 to ship it to you priority...

would like a334wx tillotson gas carb & manifold for briggs 5hp flathead or a comparable tillotson

6061 T-6 billet aluminum... 2" length... .890 bore... Fits Honda GC 160/190 engines and Mikuni VM22 carb... Will NOT work with taper bore carbs... 1 Gasket, 4 stainless 1/4" mounting screws w/lock washers, and 2 5/16" carb mounting studs w/nylock nuts included... $45...

Guys, I have a problem. I bought an aluminum intake adapter for my carburetor, to make it sit level, but I I can't get the thing on the engine. The screws are too long to get behind, or in front of the carb....the only thing I can think of is to take the manifold piece off, so I can get the...

I needed some and could not find so I made a few and sold some on ebay. need one?

I made these becouse I needed them and I sold about 12 on ebay and the air filters too. Dean Hamlin.

Well here is the 3rd and final piece from the project that never was. Its a manifold spacer with pulse fitting. It is for a GX160, GX200 or Clone..... Description: Manifold Spacer, with Pulse Fitting. Aluminum spacer with pulse fitting can be used either in front or behind carb. Run your fuel...

Anybody have one?

need a manifold that adapts a 22 or 24mm mikuni to a 5hp flathead

I want to uprate the carb on my gx160 clone, I can get a 22mm mikuni carb here in the UK but cannot source an inlet manifold! Any ideas where to get one from? Cheers Steve.