Anybody have a set laying around or measurements to make them? I have the large swing arm brackets but not the plate-like brackets for the jack shaft and driven pulley. My Gilson collection keeps growing....:ohmy:
Thanks in advance!
These are off of the Powell that I am building. I am not going to use them. They are pretty roached but can be saved. You can see somebody welded a fender onto the back bracket, but that can be ground off. Just thought I would see if anybody needed these for their build. $50.00
Let me know
WTB: Tecumseh gas tanks and brackets:
H40 White plastic Red cap center with bracket.
H40 Black plastic Red cap center with bracket
H35 Bolt On muffler 8" Black/ original finish
Thanks.
Gas tank is in good shape. 2 small dents on top one in front. No leaks. New double stick rubber on back with paper on. No rust inside. Nic and clean. Sand and repaint and you're good to go. 2 piece bracket fits h50 and h60. $45 shipped
Tecumseh fuel tank brackets upper and lower $15.00 and I'll ship them for free. Plastic tank does leak fuel, but you can have it to for the same price.
I need the brackets to mount a cover to an MTD. I have a picture of Johnny Tillotson's MTD to show the exact bike and the exact cover I have. I can't post the pic so maybe sent by e mail if you need to see it.
Any help would be great.
Doc
I'm gauging interest in who would buy these brackets if I get some laser cut?
The original bracket that I have is 14 gauge but I was going to get 10 gauge brackets made also. The 14 gauge brackets were prone to crack so the manufacturer began to double up the bracket on the later versions...
I get a lot of old clutches on my engines but this one looks particularly nice. Anyone know the Brand? Once I sand the rust off I think It'll be pretty nice. Also I've got a lot of these chain guard brackets now. Are they for any particular guard like Rupp?
These are original mounting tabs off of Bonanza BC fenders...not sure which year. A lot of times these brackets are bent or cracked or the holes have been messed with. These are in good shape and could be tack welded back on to save a good set of original fenders.
Anyway thought maybe...
I'm Restoring a 1970 Maverick Mini Trail and Instead of rebuilding whats left of my original seat pan it looks like a Z50 seat might fit and you can by those new. Would someone be willing to measure the width and length of the seat Pan. Also the Height of the actual seat from where the material...
Does anybody have a set of gas tank brackets for my BC 1400 Tank? OldMiniBikes is out of stock. I know I could make my own but it would be nice to have a correct set.:thumbsup: Thank you
Does anyone know of a place to buy front fork mount brackets for Hydro Calipers ?
I know BMI sells some but, I e-mailed them 3 weeks ago to ask which ones do I buy for these calipers. NO REPLY as yet ! :censure:
Can anyone help ? OR do I need to make my own ?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.