manifolds

All items are in used condition as you can tell, but all function perfectly. Tomar 2 disc stellar 4 clutch it comes with a 16 Tooth clutch sprocket and engagement it at around 3800, but it can be adjusted by removing the washers on the clutch or tightening or loosening the springs. Genuine...

Lot of miscellaneous intake manifolds... fit Tilly carbs. Most are flathead Briggs, but I think may be one or two that are or Animal or Clone engines. Don't know for sure. $40 for the lot. Mystery aluminum blocks... appear to be some kind of manifold, but I have been unable to track them...

I'am putting out feelers to see if there is and interest in intake manifolds for Tecumsehs , Briggs , and clones . I can build you a manifold to put the popular mikuni 22 , or a clone carb on a TEC or Briggs . I just finished one for myself that lets me put a clone carb on a HS50 . For a...

I deleted my other thread and started over because a couple of memebers pointed out that the intake on the left is for HS50. It is NOS. The one on the right is for HS40...it is used but in perfect condition. $17 each or $30 for the pair shipped...Paypal only.

I'm looking for 1 or 2 3-3.5hp Tecumseh intake manifolds like the one in the picture below. If you have one that you would like to sell let me know, thanks. :thumbsup: Sent from my iPod using Tapatalk

Was about to bend up some exhaust pipes for a friend and was woundering if 1 1/4 tube was too big. And if you have a custom header on you bike post a picture up of it. Thanks in advance

One lightly used steel angled intake manifold to fit a Mikuni VM22 carb to a B&S 5hp flathead...$15 plus shipping. One lightly used steel angled intake manifold to fit a Mikuni 22mm or 24mm taper-bore carb to a B&S 5hp flathead...$15 plus shipping.

I am feeling gracious right now.... I (unlike many others) have access to a good welder, and I'm very good with it. Need a manifold made? Need some weird-ass manifold that no website carries? PM Me and I'll see what I can do. You'll most likely only pay for materials and shipping...

anything you need made custom, send me a pm. lets work somethin out

i can do exhausts and manifolds for -gx200/clone -5hp flathead -gx390/340 -2 hp briggs or send me a exhaust gasket that fits PERFECT and ill build it off that. wheelie bars, CATCH CAN KITS, frames if you get me the wheels and sprocket, tanks, bracing, sandblasting. high TORQUE porting...

A month or two ago someone was talking about making a bunch of manifolds because they had access to a CNC machine. They were going to offer that they be sold through the OldMiniBikes site here and they would not be much over cost. I think they were talkin like $25 or so. What is the word on this...