mercury

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

mercury clutch

This H70 Tecumseh that I bought came with a Mercury centrifugal clutch. Numbers on it are 5046-22 it's for a 3/4" shaft. The drum is really loose and floppy on the center. Are there service parts available for these somewhere? I searched the forums but found little information on the Mercury...

3 nos mercury clutches left 2 5/8 11tooth 35 chain (white package ) 1 5/8 12 tooth 35 chain (orange and white) Asking $40 shipped

I'm certain it's NOS, but it does have some small nicks and scratches on it from years of shelf wear. I don't know much else about it 3/4" bore, #35 chain, 12T $85 plus shipping (OBO)

Spent the night removing some of the old clutches I've obtained from buying engines. I had sprayed PB Blaster on them for a week leading up to this as the last one I removed was an unmittigated disaster. (RIP lil Max Torque!) These all came off smooth and easy. 3 Max Torque, one Mercury...

Got it cleaned up and primed. It needs wheel bearings, a chain, handle bar clamps, and some seat repair. I'll probably paint it yellow, and I think I'll try some Krylon "Original Chrome" paint for the rims. It has a Tecumseh with a Mercury Clutch. Not sure which model or HP. I am using a...

Looking to purchase a NOS or slightly used Mercury GMBS10-12RC35 Clutch for a restoration,thanks.:smile:

Came off of a Rupp C350 ... Some wear on the teeth but overall a tight smooth working clutch ... 5/8 crank ... 12 tooth ... $22.75 or make an offer shipped to the lower 48 ... PayPal ... You pay applicable fees ... Ships from 75087

Like it says...NOS Mercury clutch. Never used...still in partial original package. It has a lil rust on it and corrosion from sitting in package or moisture. It is for a #41 chain 3/4 shaft. I have no use for it and don't have a clue what it would go on. PM me any questions. 60 bucks...plus...

I have a nice vintage Mercury clutch for sale. 3/4" bore, #35 chain. 2 allen set screws, but one is missing. Surface is slightly rusted, but seems to be in good working order. $45 shipped. PayPal preferred. I'll post pictures this afternoon.

I'm looking for one for my Lil Indian project. Needs to be in decent to new condition. Its gotta be for a #35 chain, smallest possible gear, however many teeth that is. --Joe