I bought a mini racer, fixed it up, it was losing compression around the spark plug threads, so i ordered a honda g100 head, and new piston rings for good measure.
So I installed the new piston rings and new head, I'm pretty darn sure I put everything back together right. Valves are opening...
I bought this for my predator 212 not realizing it has a different size wrist pin. Brand new in the box. Can still be used in a predator just needs a rod with a .490 wrist pin
$90 shipped OBO,
Piston Forged, 2.756, Wiseco for PREDATOR
Dia 2.756
Comp Height .640
Uses .490 Wrist pin...
I recently purchased a 78 Rockford Chibi with a Bridgestone 60cc engine that was seized by the previous owner. I have a stock sized piston, but the cylinder has been bored to the 1st over specs. So I either need a stock bore cylinder or a 1st over piston. I'll get pics soon
I have a non Hemi predator with a .020 longer rid and stock piston. I was wondering if there is enough room to throw in a flat top piston too without an issue or if I need a stock length rod? Bonus if I can use a smaller gasket!
Hello All,
Does anyone know where I can pick up a stock bore size piston for an old AH51?
These were the cross flow scavenged engines requiring the deflector topped piston.
Thanks in advance
Mark
Any issue with reusing with piston? Are the scratches on the skirt worth worrying about? I already ran a scotch brite over them.
I had just planned on ball honing the cylinder and re-ringing it.
Hsk60 tecumseh. It's a complete snow king engine with the 120vlt electric start. I will part it out or sell whole. It did run. Made some noise on acceleration. I removed the head and other parts. It is a long block at this point. Had never had the carbon cleaned from the piston. Basically the...
I bought this earlier today. I'm trying to post a few pics. The cylinder looks good, no scoring. But the piston doesn't come all the way up. I'm gonna pull the flywheel first but I think the rod might be broken.
So the ARCO H30 I picked up last weekend has no compression. I opened the head and poured oil inside and it fairly quickly got by the piston and into the sump. Pretty safe to say that this is the cause no? Bad piston rings? Ive never changed em. Anyone have or know of a decently simply step...
what all does it take to do this? probably going throw this crank in with a std length billet rod, with flat top piston. will I have to mill the piston down? looked all over the site and couldn't find anything
I have a blue PVL coil new take off $80 shipped. Also have a used WF rod with an animal piston that was taken out with less than 30 minutes on the engine $65 shipped.
I am just curious, I see on e-bay people selling pistons that say will fit 3.5 or 5 hp. engines, I always thought the 5hp piston was a monster compared to their smaller engines. Hence people use the 5hp. for racing. Am I correct in assuming they are full of :censure: here. Please advise......
Okay. So this was my first time installing a piston in anything and I messed up( I know practice makes perfect :D . So I had my 3.308 (standard size) rod on my stock predator 212cc piston (same with wrist pin but I have gx200 clips because I lost mine but they are the same size) and i gently put...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.