adjuster

Hello: Looking for advice on where to get a throttle cable adjuster (with the jam nut) to fit the OldMiniBikes R261 cable that I want to order. Going to be using it with my NOS Odeon twist grip. Don't really see the adjuster I want on the Warehouse site. I'm a little unsure of the size as I don't...

I bought some 1" Harley throttles and tried to used a 1" mini bike throttle Housing my and it didn't quite work. I bought just the Harley housing for a dual cable and the throttle feril different. I need a 5/16-18 for it. Anyone experience this same issue or know where I can get one.

Not sure I got the name correct but I need one but would consider a pair. This is the adjuster "bolt" with two nuts that attaches to the swing arm and slips through the rear axle bolt. Prefer one with original large nuts. Thanks Tom

Looking for a pair of nos cherry 7/8" right and left brake lever with the cable adjuster and ball end. Also interested if you have just a left or a right one. Thank you.

I got tired of always having to use some kind of pry bar and an extra set of hands when it was time to adjust the chains on our fleet of mini's. I cut up some 1/4" wall square tubing and used what I had in the shop to make a removable chain adjuster. I used 3/8" all thread and a 3/8" coupling...

I am in search of a rear axel adjuster for a Bronnco Tx just like this one

Off motovox. 5$ plus shipping 8oz from 10509. paypal MF PENDING

line up the push bolt with the rear oil drain plug drill two 1/4" mount holes in the motor plate and bolt it down with the push bolt retracted then you are ready to go!! . now to adjust your chain just loosen the engine mount bolts a little and screw in the push bolt until the chain is at the...

heres what I have so far

for engines with a rear oil drain plug thats center is about 3/8" from the bottom of the engine . retract the push bolt until its end is even with the body of the adjuster then line it up with the drain plug mark where your 1/4" mount holes will need to be then drill the 2 mount holes and bolt...

this one is $15 shipped it will be listed in the minibike parts section

line up the push bolt with the rear oil drain plug on a Briggs engine or any engine with a rear oil drain plug at about the same height it should work on the tecumseh HS engines but not the H engines unless you shim it higher drill two 1/4" mount holes in the motor plate and bolt it down with...

I made this several years ago and it works so awesome I wanted to share it with you . you drill 2 holes in your motor plate and bolt it down so the center bolt lines up with the rear oil drain plug then loosen the engine mount bolts a little and turn the adjuster bolt until you have the tension...

Bonanza Brake Adjuster

Bonanza Brake Adjuster

Bonanza Brake Adjuster

Busted my brake lever off the other day, i would like something like this, but one made to fit my handlebars. Professional Brake Lever - Fits 7/8" OD Handle Bars - AZ1731 (or, will the afore mentioned part fir on my bonanza?) dont care about the ball on the end at all, or chrome to...

Any body have one of these laying around that you would let go of cheap? I just need the adjuster and spring. It is for a Baja Warrior mini bike. Also need cover. Thanks.

hi guys, i was wondering if you have any idea how the old cars had adjustable timing, if i could build one for my bike?

I broke one of the eye-bolt tensioners on removal. here they are. These are 11/16" eyes with a reducer to 5/8". Has anyone seen this configuration? I am advised that the stock adjusters were 5/8" eye, but these spacers look like they belong here. need correct replacement advice please.