chain

I'm looking for a TACO clutch cover, new, used or repopped. Let me know what you got. Thanks in advance ond.

Need a chain guard for a Cat Duster

Looking for an original clutch/chain guard. Thanks. Tom

The chain on my warrior is rubbing against the nut that holds on the tensioner arm (or whatever it's called). You can see the nut in the middle of the pic. It's almost like the chain is too long, but I counted the links and counted the links on an internet picture, and it seems the same...

Up for sale is a Atlas Chrome Chain Guard with mounting brackets & hardware included I was unsure what this came off of so i put a WHAT IS IT post on OldMiniBikes Measurements are 16" long x 5" High x 2" Wide The chain guard is not perfect but not bad...

Looking for parts to complete my Wacky chopper. Any other parts could be useful as well. Thanks in advance. ....Billy

Hi all. Just picked up a db30 straight frame and the rear wheel has quite a bit of wobble to it. It's also missing the chain guards too which seem impossible to locate for the older model. Anyone have anything laying around??

I am putting an EK high tensile chain on my Trail Horse and, of course, I am one link short with the engine all the way back in it's slots. Does anybody know of a place I can order a single link? I've been searching and searching with little luck. BRAAAAAP

I noticed in another persons Alsport that there was an extra sprocket that seemed to act as a chain tensioner. Mine has a bracket in that location but no extra sprocket in that location. Now, on my jackshaft itself, there is an extra sprocket that I can't figure out what it's purpose would be...

I am looking for the chain guard and the billet looking nut for handle bars if anyone has nova parts, I could use them. Thanks!

Got the Gote about ready for the maiden ride. How much slack should I set in the 2 chains ? I have everything level and square..and belt is adjusted where it should be..Thanks..JV..

About 2 weeks ago my stock Doodle Bug chain gave up the ghost. One of the links slide over and the chain started to slap really bad and some of the links were even bent. I found an awesome chain on Comet Karts sales called a #35 space chain and I purchased a 5-foot section to replace my stock...

Hello from Oklahoma. First off I am not a small engine mech. So bear with me please. I just bought a BAJA MB 165 for $40. The previous owner stated that it was running less than a year ago (YEA RIGHT!!!). The carburator was in a plastic jug, well part of it was. I finally had to replace...

Well my chain of my Fox Spoiler slipped once again yesterday, but this time the chain is too tight for me to move it back on the jackshaft sprocket. I have found the master link on the chain, but I'm too afraid to try and get it off because I don't want to break anything. Is there a proper way...

I would like to buy outright or have a memeber loan or make detailed drawings/photos of the chainguard used on this TACO minibike. It uses two bolts to mount to the engine mounting plate. I cannot find any other picture of this chain guard anywhere and PLEASE POST HERE if you have another...

Earlier today I was about to race a doodlebug on my Fox Spoiler and off the line my rear chain slipped from my jackshaft. I noticed there is a bit of movement with the shaft inside the bearings so would that mean I just need a new shaft in general? When I move the shaft away from the back tire...

how to measure #40/41/420 chain

how to measure #35 chain

how to measure #35 chain

I see what looks like the same one advertised on ebay but says 40 or 41 chain. https://www.OldMiniBikes.com/Steel-Sprocket-60-Tooth-41-Chain.html?category_id=1317 Sprocket 60 Tooth 40 41 Chain Mini Bike Go Cart Go Kart | eBay Thanks Kevin