Hi everyone,
I'm looking at building my first mini bike and I'm not sure what sprocket size to put on and what ratio I should go for. It's going to be a lightweight fat tire bike similar to the one jeep2003 built. I'll be using on muddy/ hilly terrain. This is what I'm thinking so far...
I'm Looking for either a 60 or 72 tooth sprocket for a Simplex Mark II Go Kart. It would be great if the sprocket is in usable condition but I will also consider a sprocket with worn teeth, I can use the hub.
Thanks
I'm Looking for either a 60 or 72 tooth sprocket for a Simplex Mark II Go Kart. It would be great if the sprocket is in usable condition but I will also consider a sprocket with worn teeth, I can use the hub.
Thanks
Do I need to move the engine to the right? I worked hard to center the rear wheel, which included placing a spacer in between the drum and back plate. So, I would rather not move the wheel out to the left. If I move the engine, should I order an engine plate before the re-location? or just cut...
Right now I have installed on my motovox a 212cc predator with 14 inch tire diameter, 12 tooth clutch and 58 tooth rear sprocket.
Will it be okay to switch the clutch to a 13 tooth and the rear sprocket to a 53 tooth without burning up the clutch?
I called a Craigslist poster this morning and picked up a Manco Streaker. So, I went down to his pawn shop and bought the roller. I have a fresh 79cc Predator waiting for it. It needs a sprocket, which I do not have, but I have might have most of the missing pieces needed to dress this...
I ride my mini bike pretty hard and throw the chain twice in an hour of hard riding. Mostly street riding, but when I hit a bump in the road at full throttle it may throw the chain. I currently run a 12t clutch 59t split sprocket with the OldMiniBikes split sprocket adapter. I was thinking about either...
just got an older lil indian roller, it has a 36 tooth 420 chain back sprocket. its in good cond. should I keep running that or change out to a 60 tooth or so larger?????? what would the difference be in top or bottom end???? thanks much for any info
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.