Howdy All,
I have an Azuza Mini Bike with a 6 HP OHV Tecumseh with a TAV2. I want to build a side car for my two girls to mess around with. The mini bike has 8" Azuza Tri Star rims with 480/4-8 studded tires on them. This mini bike is way over powered. It is hard to keep the front tire on...
Hello, the previous owner of my gx140 motor disconnected the governor linkage and the stud is only sticking about the case about 1/8". It sounds like it's hitting something inside. What would be the easiest fix for this? I was thinking of tacking a bolt on it to pull it up and drilling a cotter...
Just scored a pair of bonanza 6" kidney beans and was wondering what size tires will fit them. Also where exactly is a tires size determined ,Inside of bead or further out at the outermost edge of the wheel?
Ignorant in San rafael
Found this complete H30 from an ARCO today. H30 35260H 1971. Even all the minibike throttle linkages are there and connected. All silver this time.. No spark or compression. Not stuck at least. Havent opened it yet but hopefully its nothing major. Looks like the original carb too...
Up for sale is a nice set of go power type II's. They have been cleaned and new bearings installed. On the inside of the rim they do have some corrosion. 75 plus shipping.
I rode this go kart when I was in middle and highschool so it's been stored easily 15 years.
I want to get it running to take my niece around. The clutch and chain are toast. I didn't realize a clutch is $40 for a Briggs 5hp.
Question:
Replace clutch or install the 6.5hp Predator...
If you look inside the open end of the long tube you can see the edge of a liner or sleeve cut at an angle. Very thin
Is that a liner / sleeve inside the pulsajet carbs ?
It it removable ?
Grind the edge smooth ?
I have a 2011 MB200 Baja and went to install a high flow filter and rejet my carb today. When I went to remove the bowl to swap out the jets I notice that the bowl appears to be riveted on. Has anyone ever seen this before? My other Mini Baja has a normal bolt holding the bowl on. Is there any...
I have some 50' rolls of new 1.5mm inner wire if someone needs some for a long throttle cable or choke cable . this has no outside sheath or ends for the cable , just the inside cable itself . If you need to make your own cable Pm me and I will cut you off the length you need and send it to you .
hey guys,
I have my briggs and stratton tank and the inside is super clean, it's only rusty on the reserve pick up for the carb, my motors freshly rebuilt so I don't want to suck up any c:censure:p. can i use naval jelly to get the rust out of the reserve? or does any one else have any better...
So.. it came today! :-)
It was a PAIN to install! Its such a hard rubber that the bead WOULD NOT go around without pulling the rim through to the inside of the tire. I had to eventually lean on a concrete wall, stand on it with all 220lbs of my weight with both feet, and use a crowbar...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.